-
... e. in - the signal to write to the buffer. phase - DelTapWr outputs its current sample value for use in the phase argument in DelTapRd DelTapRd tap a delay line from a DelTapWr UGen DelTapRd.ar(buffer, phase, delTime, interp, mul, add ) Del ...
-
Slope slope of signal Slope.ar(in, mul, add) Slope.kr(in, mul, add) Measures the rate of change per second of a signal. Formula implemented is: out[i] = (in[i] - in[i-1]) * sampling_rate in - input signal to measure. ( { var a, b, c, scale; ...
-
... se oscillator Impulse.ar(freq, phase, mul, add) Outputs non band limited single sample impulses. freq - frequency in Hertz phase - phase offset in cycles ( 0..1 ) { Impulse .ar(800, 0.0, 0.5, 0) }.play { Impulse .ar( XLine .kr(800,100,5), 0 ...
-
... ates the values -1 or +1 at a rate given by the nearest integer division of the sample rate by the freq argument. It is probably pretty hard on your speakers! freq - approximate rate at which to generate random values. ( SynthDef ( "help-LF ...
-
... ar trigger to start a new grain. If ar, grains after the start of the synth are sample accurate. The following args are polled at grain creation time dur - size of the grain (in seconds). sndbuf - the buffer holding a mono audio signal. If ...
-
... aximally one per control period). T2K.ar(in, offset) in - input signal offset - sample offset within control period // example ( { var trig = Impulse .kr(MouseX.kr(1, 100, 1)); Ringz .ar(T2A.ar(trig), 800, 0.01) * 0.4 }.play; ) // compare w ...
-
Loudness extraction of instantaneous loudness in sones sones = Loudness.kr(chain, smask=0.25, tmask=6) chain [fft] - Audio input to track, which has been pre-analysed by the FFT UGen; see examples below for the expected FFT size smask [sk] ...
-
... mething equivalent for testing d= Buffer .read(s, "/Volumes/data/stevebeattrack/samples/100.wav" ); d= Buffer .read(s, "/Volumes/data/stevebeattrack/samples/019.wav" ); //very feature dependent ( a= SynthDef ( \help_beattrack2_1 ,{ arg vol= ...
-
... his is because there is a feedback delay (the server's block size ), usually 64 samples, so that calculation can reiterate over its own outputs. For single sample feedback, see: Document .open( "Examples/demonstrations/single_sample_feedbac ...
-
... hase,mul, add) Very fast sine wave generator (2 PowerPC instructions per output sample!) implemented using a ringing filter. This generates a much cleaner sine wave than a table lookup oscillator and is a lot faster. However, the amplitude ...