-
... leave it as it is. If it turns out the response of the resonator is very low in amplitude, one can always increase the gain of the second order section ugens during the simulation (this will have exactly the same effect, although will be sl ...
-
... ntensity with which it was pressed. A typical mapping for velocity would be the amplitude of a sound such that it gets louder with the amount of energy applied to press the corresponding key. When the key is lifted again (i.e. the note is r ...
-
... t, dec, sus, rel]), doneAction: 2); Out.ar(out, sig ! 2 * env * amp) }).add; // amplitude modulation synth SynthDef(\ampMod, { |out, in, dev = 1, amp = 1, mix = 1| var sig, inSig = In.ar(in, 2); sig = inSig[0] * (inSig[1] * dev + DC.ar(1)) ...
-
... re the half waveset at index 5 (735-740) has a length of only 5 samples and the amplitude is low. // zero crossing indices z.loadToFloatArray(action: { |b| b.postln }) // the signal is hardly audible, but there as freqscope shows x = { Zero ...
-
... N Arguments: outs array of destination channels (or single value) amps array of amplitudes for each channel (or single value) ins array of source channel offsets within the bus (or single value) vol Overall volume (multiplied by amps) fadeT ...
-
... fault to repeats = inf. ( y = Pbind(\type, \set, // sequencing of durations and amplitudes quite fixed, just global tempo and amp control \dur, PLshufn([0.15, 0.15, 0.35]) / PL(\tempo), \amp, PLrand([0.05, 0.12, 0.2]) * PL(\amp), \soundMix, ...
-
... ck definitions, which can help to save a lot of UGens. WARNING: Be careful with amplitudes, feedback can become loud! It is highly recommended to take measures to avoid blowup, e.g. by limiting operators (tanh, softclip, distort) and/or usi ...